Rule of the Month: Dropping

Written by NCGA Staff | Jul 3, 2023 3:28:35 PM

When taking relief, whether with penalty or without, you must drop a ball. The ball must be dropped straight down from knee height, must be dropped by you (or your partner), must first strike the ground within your relief area or on the line when taking back-on-the-line relief, and must remain within the relief area. Your caddie is not allowed to drop your ball.

The relief area is always measured from a reference point. There are different reference points used for different types of relief. The reference point for taking lateral relief for an unplayable ball is simply the spot where the ball lies. For a ball in a penalty area, it is the spot where the ball crossed the edge of the penalty area. When taking back-on-the-line relief, the reference point is the spot on the line where the ball first touches the ground when dropped. When taking relief from things like temporary water, ground under repair, cart paths, and sprinkler heads (abnormal course conditions), the reference point is the nearest point of complete relief. This is the spot on the course nearest to where your ball lies, but not nearer the hole, where you could play your next stroke with no interference from the condition you’re taking relief from.

The size of the relief area is measured from the reference point and is determined by the type of relief you are taking (one club-length for things like cart paths and ground under repair, or two club-lengths for lateral relief for an unplayable ball or a ball in a red penalty area). If the ball doesn’t stay in the relief area after dropping it, simply drop it again. If it again doesn’t stay in the relief area, place a ball on the spot where it struck the ground on the second drop.

When taking relief, a club-length is always the length of the longest club in your bag (excluding your putter). For most players, this will be their driver. You may leave the headcover on when measuring, but the extra length doesn’t count – the club-length is still simply the length of the driver itself.

FAQs: